Cross Core® Traders In Sunpura
Product is guided to the high speed rotating impeller. When product reaches the impeller, it revolves at high speed inside the cutting head. Centrifugal force propels the product outward past the cutting edges of the stationary reduction head. Small portion of product projecting into the spaces between the separators are cut off into flakes by spaced columns of vertical edges. These flakes fly outward away from the cutting head.
Knives
Knife on the impeller is used to pre chop and guide the product specially leaves to the impeller.
Food Industries
- Granulate any Nut Paste or make a smooth Peanut Butter.
- Make Paste of Any Fruits and Vegetables.
- Emulsifying Oil for Mayonnaise.
- Communication of Corn for Cream Style Corn Components.
Chemical, Nutraceutical and Pharmaceuticals
- Granulate any Nut Paste or make a smooth Peanut Butter.
- Make Paste of Any Fruits and Vegetables.
- Emulsifying Oil for Mayonnaise.
- Communication of Corn for Cream Style Corn Components.
Cutting Head
Inside the cutting head impeller forces the product against uniformly spaced thin horizontal separators. The cutting head is a ring comprises of uniformly spaced vertical slots each with two knife edges. Each vertical edge is a sharp knife edge. The whole tool is joint less for maximum strength and is made of high quality food grade metal i.e. SS316, Die Steel. When product passes through the fine slots, the controlled size reduction takes place.
How Cross Core® Processor Works?
- Product is poured through Hooper which reaches the rotating screw through gravity.
- Rotating screw moves the product and takes it towards the impeller tool which is covered with splasher.
- Feed rate of screw can be controlled by varying the speed of driving motor placed behind Hooper.
- Impeller projects the product to tool with high speed and force.
- Splash case prevents the splashes of product to spread out side so it concentrates it in downward direction.
- Final product is taken out below the splash case by placing a collecting container below it.
- Final product is taken out by gravity.
- The pulley and belt drive is used to increase the speed of impeller.
- All the mountings are fixed on table.
- All non contact parts are SS 304 and all the contact parts are SS 316.
Where to Use Cross Core®?
- Consistent particle size distribution
- High-shear dispersion and emulsification
- Dry and wet milling with minimal changeover
- Shear-sensitive and high-viscosity material handling
- Batch and continuous processing capabilities
| Serial No. | Grit Size | Material Description |
|---|---|---|
| 1 | 0.4 | SS 316, Die Steel |
| 2 | 0.5 | SS 316, Die Steel |
| 3 | 0.7 | SS 316, Die Steel |
| 4 | 1.0 | SS 316, Die Steel |
| 5 | 1.2 | SS 316, Die Steel |
| 6 | 1.5 | SS 316, Die Steel |
| 7 | 1.7 | SS 316, Die Steel |
| 8 | 2.0 | SS 316, Die Steel |
| S.No. | Model | Horse Power (H.P) |
|---|---|---|
| 1 | 400 | 40 |
| 2 | 600 | 60 |
| 3 | 750 | 75 |
| 4 | 1000 | 100 |
